CAT 3126B Fault Code: 102-7 PID: Flash Code 25 SPN: 102 FMI: 7 Boost Pressure not responding
The Engine Control Module (ECM) detects the following conditions:
•The signal for boost pressure has been more than 172 kPa (25 psi) for more than 0.5 seconds.
•The fuel rate is 80% of the maximum value for the current torque map.
•102-03 diagnostic code is active.
This engine utilizes a wastegate control valve that is electronically controlled in order to precisely regulate the boost pressure. The Engine Control Module (ECM) monitors the signal from the boost pressure sensor in order to determine the boost pressure in the intake manifold. The ECM uses this information and other information that is related to the current power demand and the current engine operating conditions in order to determine the optimum position of the wastegate valve at the turbocharger.
The turbocharger’s wastegate valve regulates the amount of exhaust gas that is allowed to bypass the turbine wheel of the turbocharger. This allows the ECM to control the speed of the turbocharger and the boost pressure.
Probable Causes:
1) ECM Connection
2) Wastegate control solenoid (Can be replaced instead of the entire valve)
3) Harness between the ECM and the wastegate control solenoid
4) ECM Failure
5) Air inlet system restrictions or exhaust system restrictions
6) Drain orifice plugged
