Allison WTEC II Fault Code: 42 PID: SPN: 23 FMI: Short-to-battery, H solenoid circuit
Main code 42 indicates the ECU has detected a short-to-battery condition in a solenoid wiring circuit. Solenoid has a driver only on the high (power) side of the solenoid. Even though the driver can be turned off, a stuck solenoid is shorted-to-battery which means it is continuously powered at an unregulated 12V or 24V instead of a regulated (pulse width modulated) voltage. A power-side driven solenoid stuck closed will not allow current regulation and the same code will occur. Eventually, the solenoid coil will burn up and become open. If the vehicle is turned off and restarted, a Code 41 XX occurs in early units and a Code 45 XX in later units.
Subcode will not trigger the DO NOT SHIFT light.
Related products
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00
