Allison 3000 & 4000 Gen 4 Fault Code: P2814 Pressure Control Solenoid 6 (PCS6) Control Circuit Low

DIAGNOSTIC RESPONSE:
DNS, SOL OFF (hydraulic default)

CIRCUIT DESCRIPTION:
Pressure Control Solenoid 6 (PCS6) is a normally closed solenoid used to apply the C6 clutch in Low (L) range (7-speed models only). The Transmission Control Module (TCM) commands the solenoid ON to produce hydraulic pressure in the clutch apply circuit. When PCS6 is commanded OFF, the clutch pressure is released. The TCM sends control current to PCS6 from High Side Driver 1 (HSD1) via wire 111. HSD1 is continuously ON unless the TCM detects a fault condition. The TCM regulates the amount of current to PCS6 by switching PCS6 low side driver ON and OFF. Wire 178 completes the circuit between PCS6 and its low side driver. DTC P2814 indicates that the TCM has detected a failed low condition in the PCS6 electrical circuit. The condition may exist in the high side (wire 111) or low side (wire 178).

CONDITIONS FOR RUNNING THE DTC:
TCM initialized normally and engine speed above 200 rpm.

CONDITIONS FOR SETTING THE DTC:
This DTC sets when the TCM detects PCS6 low side driver has been detected in a failed low state.

ACTION TAKEN WHEN THE DTC SETS:
When DTC P2814 is active:
1. If failure occurs while in a forward range, then shift to another forward range. If failure occurs while in Neutral (N), the transmission remains in Neutral (N). If failure occurs while in Reverse (R), transmission remains in Reverse (R) or shifts to Neutral (N). Once range is attained, transmission will be locked in range. There is no response to shift selector requests.
2. DTC is stored in the TCM history.
3. The CHECK TRANS light illuminates.
4. The TCM freezes shift adapts (DNA).

CONDITIONS FOR CLEARING THE DTC:
Use the diagnostic tool to clear the DTC from the TCM history. The TCM automatically clears the DTC from the TCM history if the vehicle completes 40 warm-up cycles without failures.

DIAGNOSTIC AIDS:
DTC P2814 can be caused by:
1. PCS6 issues such as:
– W178 shorted to another wire or ground in chassis harness.
– W178 (terminal 7 of 20-way) shorted to another wire or ground in internal transmission harness.
– PCS6 defective.
2. Broken on defective connector assemblies allowing pushed back pins to short together.
3. Unlocked connectors, missing seal plugs allowing moisture in connectors.
4. Defective TCM.

Review applicable information in Control System and Transmission Specifications to find additional circuit specifications, system and connector diagrams, and troubleshooting tips.