Allison 3000 & 4000 Gen 4 Fault Code: P0733 Incorrect 3rd Gear Ratio

DIAGNOSTIC RESPONSE:
DNS, Attempt 4th, then 6th

CIRCUIT DESCRIPTION:
The Transmission Control Module (TCM) uses input from the turbine speed and the output speed sensors to determine the current commanded steady-state gear ratio. The TCM then compares the known gear ratio to the calculated gear ratio for the current range.

CONDITIONS FOR RUNNING THE DTC:
1. Hydraulic system is pressurized.
2. No shift in progress.
3. Hydraulic default condition not present.
4. Output speed is above 200 rpm.
5. Engine initialization or shutdown is not in process.

CONDITIONS FOR SETTING THE DTC:
DTC P0733 sets during steady-state condition when the calculated third gear ratio differs from the known third gear ratio for more than 2 seconds.

ACTION TAKEN WHEN THE DTC SETS:
When DTC P0733 is active, the following conditions will occur:
1. The TCM attempts to shift to fourth. If unsuccessful, the TCM commands sixth range.
2. While diagnostic response is active, the TCM ignores shift selector inputs.
3. The CHECK TRANS light illuminates.
4. DTC is stored in the TCM history.
5. TCM inhibits TCC engagement.
6. TCM freezes shift adapts (DNA).

CONDITIONS FOR CLEARING THE DTC/CHECK TRANS LIGHT:
Use the diagnostic tool to clear the DTC from the TCM history. The TCM automatically clears the DTC from the TCM history if the vehicle completes 40 warm-up cycles without the DTC recurring.

NOTE: This DTC requires Clutch Test using the diagnostic tool to detect clutch slip during a partial stall and also to pressurize clutches for measurement without needing to drive the vehicle. Note that main pressure and clutch pressures are reduced when the Main Mod Solenoid is energized. Low commanded Main Mod solenoid pressures shown in Data Monitor correlate to reduced main pressure and clutch pressures. Main pressure is reduced by Main Mod in N (Neutral), 1 (First Range), and 2 (Second Range) when engine speed is below 1500 rpm. Higher Main Mod commanded pressures correlate to no reduction in main pressure and clutch pressures. Refer to First Steps and Tips for Troubleshooting and the OEM Technician’s Library for more information about the action requests for Clutch Test, Full Main Pressure Test, and also the procedure for Stall Testing.

DTC P0733 may be caused by:
1. Output speed sensor signal circuit issues.
2. Turbine speed sensor signal circuit issues.
3. Low clutch pressures, main pressure, or control main pressure.
4. Control module issues like stuck/sticky valves, mechanically defective solenoids, broken springs, damaged valve bores, plugged suction filter, damaged gaskets, excessive leaks to exhaust, etc.
5. Transmission issues such as damaged output speed sensor wheel slot, worn and/or damaged seals or seal rings, dislocated snap rings, worn clutch packs, rotating drum damage (affecting turbine speed pickup), debris, excessive hydraulic circuit leaks to exhaust or other hydraulic circuits.

NOTE: Damage to the output speed sensor wheel slot is an indication the driveline does not meet ATI specifications. Correct all driveline issues before putting transmission back in service.

6. Clutch system issues causing a clutch not to release.
7. Issue with TCM.