Allison 3000 & 4000 Gen 4 Fault Code: P0604 Internal Control Module Random Access Memory (RAM) Error
DIAGNOSTIC RESPONSE:
Use default sump temperature
CIRCUIT DESCRIPTION:
The Transmission Control Module (TCM) performs an internal memory self-test at power up that writes and reads patterns at specific RAM locations to verify that all addresses and data lines are functioning correctly.
CONDITIONS FOR RUNNING THE DTC:
TCM software level January 2011 or higher.
CONDITIONS FOR SETTING THE DTC:
DTC P0604 sets if the TCM determines the TCM memory pattern that was written is not what was read from TCM memory during the self- test.
ACTION TAKEN WHEN THE DTC SETS:
1. The CHECK TRANS light illuminates.
2. DTC is stored in the TCM history on next key cycle.
3. All-segments symbol illuminates in both shift selector displays.
4. The TCM returns to the boot program.
5. The TCM inhibits shifts to range.
CONDITIONS FOR CLEARING THE DTC:
Replace TCM.
DIAGNOSTIC AIDS:
Replace TCM.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00
