Allison 1000 & 2000 Gen 5 Fault Code:P0602 TCM Not Programmed
CIRCUIT DESCRIPTION:
At the power up and after clearing DTCs, the TCM performs a self-test to determine if the calibration in memory is valid.
ACTION TAKEN WHEN THE DTC SETS:
1. DTC P0602 is stored in the TCM history.
2. The TCM does not illuminate the CHECK TRANS light (non-OBD II strategy).
3. The TCM returns to the boot program, and then waits to be recalibrated.
4. Transmission operates in hydraulic default, Reverse, Neutral, and 3rd ranges.
5. DTC is stored in the TCM history.
CONDITIONS FOR CLEARING THE DTC:
TCM must be recalibrated with a valid VEPS calibration.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
