Facebook-f Twitter Github Bitbucket
Shop
Account
Cart $1,230.00
6
6
Subtotal: $1,230.00
CLAAS MetaDiag 2007 Update 2016 is a crucial software tool for diagnosing issues in CLAAS agricultural machinery. It enhances efficiency and supports maintenance activities through advanced features and user-friendly design. This update includes improvements in diagnostic capabilities, compatibility, and installation processes. Designed for easy use, it is vital for technicians managing heavy machinery and trucks, ensuring optimal performance and reduced downtime.
CLAAS MetaDiag 2007 Update 2016
1 × $200.00
Isuzu E-IDSS 2023 Diagnostic Software is designed for efficient diagnostics and repairs of Isuzu heavy machinery and trucks. It combines advanced technology with user-friendly features to facilitate accurate troubleshooting. The software supports a wide range of Isuzu models and enhances the repair process. Installation is straightforward and can be performed remotely via TeamViewer, ensuring quick setup for technicians.
Isuzu E-IDSS 2023 Diagnostic Software
1 × $150.00
The ISUZU G-IDSS Domestic Japan 2024 is an advanced diagnostic tool designed for Isuzu vehicles. This version introduces several key features that enhance vehicle maintenance and streamline diagnostics. With improved user interfaces and multi-language support, technicians can efficiently navigate the system. The G IDSS also offers advanced programming capabilities, allowing for precise control updates and accurate diagnostics.
ISUZU G-IDSS Domestic Japan 2024 Diagnostic Software
4 × $220.00
Subtotal: $1,230.00
View cart Checkout

PACCAR PX-8 CM2150 (2007-09) Fault Code: 351 PID: SID 251 SPN: 627 FMI: 12 Injector Power Supply – Bad Intelligent Device or Component. The ECM measured injector boost voltage is low.

Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM. If necessary, recalibrate the ECM.

This fault code will become active when the engine is running, the primary engine speed sensor signal is present, the battery charge is above a minimum threshold, and, at the same time, the measured injector power supply voltage is lower than the commanded injector power supply voltage.

This fault code will become inactive whenever the keyswitch is turned on.

This fault code will become inactive whenever the engine is running and measured injector power supply voltage reaches the commanded injector power supply voltage.

Possible repairs:

1)Clean the battery terminal connections.
2)Replace the ECM.

Categories , , Tags , , , , , , , , , , , , , , , , , , , , , , , , , , , , ,
Facebook Twitter Youtube
Wiring Diagrams
Component Locators

Related products