Cummins ISB4.5 CM2150 Fault Code: 1677 PID: 205C SPN: 3031 FMI: 4 Aftertreatment Diesel Exhaust Fluid Tank Temperature Sensor – Voltage Below Normal or Shorted to Low Source.

Circuit Description
The aftertreatment diesel exhaust fluid temperature sensor is used by the electronic control module (ECM) to monitor the temperature of the aftertreatment diesel exhaust fluid inside the diesel exhaust fluid tank. The ECM monitors the voltage on the signal pin and converts this to a temperature value.

Component Location
The aftertreatment diesel exhaust fluid temperature sensor is located in the diesel exhaust fluid tank. Location of the tank and temperature sensor is OEM dependent. Refer to the OEM service manual for more information.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position.

Conditions for Setting the Fault Codes
-The ECM detects that the aftertreatment diesel exhaust fluid tank temperature sensor signal voltage dropped below a calibratible value while the keyswitch was in the ON position.

Action Taken When the Fault Code is Active
-The ECM illuminates the amber CHECK ENGINE lamp and/or the MIL immediately after the diagnostic runs and fails.
-Engine torque will be reduced.

Conditions for Clearing the Fault Code
-This fault code can not be cleared with INSITE™ electronic service tool.
-To validate the repair, start the engine and let it idle for 1 minute.
-The ECM will turn off the amber CHECK ENGINE lamp and/or MIL immediately after the diagnostic runs and passes.
-Use INSITE™ electronic service tool to verify the fault code is inactive.
-The inactive fault code will be cleared from the memory after 9600 hours of engine operation without a reoccurrence.

Shop Talk
The aftertreatment diesel exhaust fluid temperature sensor shares return wires in the engine harness with other sensors. A shorted return can cause multiple fault codes to be active. Before troubleshooting Fault Code 1677, check for multiple fault codes.

Possible Causes
-Signal shorted to ground in the harness
-Signal shorted to return or ground in the sensor