Cummins ISB CM550 (1990-94) Fault Code: 143-SN PID: 100 SPN: 100 FMI: 1 Oil Pressure Switch Circuit
Circuit Description
The oil pressure sensor is used by the engine control module (ECM) to monitor the lubricating
oil pressure. The ECM monitors the voltage on the signal pin and converts this to a pressure
value. The oil pressure value is used by the ECM for the engine protection system.
Component Location
The oil pressure sensor is located on the engine block, below and to the right of the ECM.
Shop Talk
1) Confirm that the oil pressure sensor supply voltage is between (+) 4.5 and 5.25-VDC at
the sensor.
2) Verify, with the driver, the engine speed at which the fault occurs. If the engine is being
operated at too low of a speed under load, the oil pressure can drop below the engine
protection limits.
3) Connect a manual gauge to monitor engine oil pressure and compare to the value in
your diagnostic tool.
Related products
-
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00
