Cummins ISB CM550 (1990-94) Fault Code: 488 PID: 105 SPN: 105 FMI: 0 Intake Manifold Air Temperature Sensor – Engine Protection Circuit
Circuit Description
The intake manifold air temperature sensor is used by the electronic control module (ECM) to
monitor the temperature of the engine intake air. The intake air temperature is used by the
ECM for the engine protection system, and the timing and fueling control.
Component Location
The intake manifold temperature sensor is located on the side of the intake manifold, toward
the rear of the cylinder head, near cylinder No. 6.
Shop Talk
This is a warning fault code. If the intake manifold air temperature continues to rise, Fault Code
155 will become active and shut down the engine.
Possible causes:
1) clogged, dirty, inadequate capacity air cleaner element
2) faulty fan clutch
3) intake restriction
4) 010-031 in the Troubleshooting and Repair Manual, ISB Engines, Bulletin No. 3666193.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS
