PACCAR MX (2004 Emissions) Fault Code: P1235 Turbo Speed – Data Erratic, Intermittent, or Incorrect
PACCAR MX (2004 Emissions) Fault Code: P1235 Turbo Speed – Data Erratic, Intermittent, or Incorrect
SET CONDITIONS:
The PCI ECU (D420) detects that the measured turbo speed differs too much from the expected turbo speed for more than 120 seconds.
DIAGNOSTIC CONDITION:
This diagnostic runs when the engine is running at a steady load and the coolant temperature is above 50?C [122?F].
CORRESPONDING OBD READINESS MONITOR:
None
RESET CONDITION:
This DTC changes to inactive when the fault is no longer detected.
REPAIR VERIFICATION:
1. Clear all DTCs.
2. Test drive or operate the vehicle to meet the diagnostic conditions and set conditions.
3. Did the DTC come back? (Can be pending, inactive or active)
– No, repair successful
– Yes, repair unsuccessful
POSSIBLE CAUSES:
1. Fault on turbo speed sensor
2. Fault on boost pressure sensor
ADDITIONAL INFORMATION:
1. The turbo speed is measured by the turbo speed sensor (F683).
2. The boost pressure sensor signal is used to calculate the expected turbo speed.
-
Scania SDP3 2.48.6 Diagnosis & Programming for VCI 3 VCI3 without Dongle
Scania $30.00Rated 0 out of 5 -
Navistar international OnCommand service information 2018 software trucks
Navistar $50.00Rated 0 out of 5
-
Volvo Premium Tech Tool PTT 2.8.130 Diagnostic Software 04.2022 ACPI ( 1 PC )
Trucks software $143.00Rated 0 out of 5 -
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR $60.00Rated 0 out of 5 -
download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi $76.00Rated 0 out of 5