Cummins ISB6.7 CM2350 (2013-17) Fault Code: 3497 PID: SPN: 1761 FMI: 17 Aftertreatment 1 Diesel Exhaust Fluid Tank Level- Data Valid but Below Normal Operating Range- Least Severe Level

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 3497 PID: SPN: 1761 FMI: 17 Aftertreatment 1 Diesel Exhaust Fluid Tank Level- Data Valid but Below Normal Operating Range- Least Severe Level

Circuit Description
The aftertreatment diesel exhaust fluid level sensor is used to monitor the diesel exhaust fluid level inside the diesel exhaust fluid tank.

Component Location
The aftertreatment diesel exhaust fluid tank level sensor is located in the aftertreatment diesel exhaust fluid tank. Location of the tank and level sensor is OEM dependent. Refer to the OEM service manual.

Conditions for Running the Diagnostics
1)The diagnostic runs continuously when the following conditions are met:
2)Keyswitch is in the ON position or when the engine is running.
3)Ambient temperature is above -20?C [-4?F].
4)Vehicle altitude change is less than 305 m [1000 ft] in 1 hour.

Conditions for Setting the Fault Codes
The diesel exhaust fluid tank level was low.

Action Taken When the Fault Code is Active
The Diesel Exhaust Fluid Lamp will be illuminated.

Conditions for Clearing the Fault Code
1)To validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.
2)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
3)The ECM will turn off the diesel exhaust fluid lamp immediately after the diagnostic runs and passes.
4)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Shop Talk
This fault code indicates that the diesel exhaust fluid level is low, and the tank must be refilled at the operator’s earliest convenience.

Reference the appropriate OEM wiring diagram when troubleshooting circuits that utilize wiring supplied by the OEM.

For intermittent power supply and datalink communication issues with Aftertreatment Components, it is highly recommended that the OEM Power Distribution Center fuses and relays be thoroughly checked for loose, missing or intermittent connections.

Possible Causes:
1) ECM calibration