Detroit DD16 GHG14 (2014-16) Fault Code: SPN 3250 FMI 0 (ACM) Diesel Oxidation Catalyst Outlet Temperature Very High
DESCRIPTION:
This code sets when the diesel oxidation catalyst (DOC) outlet temperature is greater than 760°C (1400°F) for more than two seconds.
MONITORED PARAMETER:
Diesel oxidation catalyst temperature sensor.
TYPICAL ENABLING CONDITIONS:
Always on
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous when enabling conditions met.
TYPICAL DURATION:
Two seconds
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
25% Derate
VERIFICATION:
Parked regeneration
NOTE: If any other codes active, fix those first.
PROBABLE CAUSES:
1. DOC outlet temperature sensor harness/connector.
2. DOC outlet temperature sensor.
3. Failed fuel injector.
4. Remove the DPF and inspect for coolant or oil contamination. If found, find source of leak.
5. Perform a parked regen.
6. Electrical connections upstream of the ECM can also cause this code: ATD harness 10-pin connector, VIH 31-pin connector, and MCM 120-pin connector.
7. DPF inlet pressure sensor.
8. DPF inlet pressure sensor harness/connector.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
