Detroit DD16 GHG14 (2014-16) Fault Code: SPN 4193 FMI 17 (MCM) Coolant Temperature Sensor Monitor
MONITORED PARAMETER:
Coolant inlet temperature sensor.
TYPICAL ENABLING CONDITIONS:
1. Engine speed 500 – 2500 rpm.
2. Coolant temperature is greater than 65°C (149°F).
3. Battery voltage is greater than 11vDC.
4. Run engine greater than 60s.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Once per drive cycle.
TYPICAL DURATION:
30
DASH LAMPS:
MIL
VERIFICATION:
1. Start engine.
2. Warm up such that coolant temperature is greater than 65°C (149°F).
3. Ensure battery voltage is greater than 11 vDC and engine has been running for at least one minute.
4. Bring engine to idle speed.
5. Being certain that it is greater than 500 rpm.
NOTE: If there are any cooling system faults or conditions, repair those first.
PROBABLE CAUSES:
1. Engine coolant thermostat.
2. Inlet and/or outlet coolant temperature sensor.
3. Inlet and/or outlet coolant temperature sensor connector/harness.
Related products
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00
