Detroit DD16 EPA10 (2010-13) Fault Code: SPN 84 FMI 13 (MCM) J1939 Wheel-Based Vehicle Speed Sensor Signal from Source #1, #2, or #3 is Missing
DESCRIPTION:
J1939 vehicle speed sensor signal missing.
MONITORED PARAMETER:
Vehicle Speed Sensor (VSS).
TYPICAL ENABLING CONDITIONS:
1. Rpm greater than 1500.
2. Torque demand on.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous when enabling conditions met.
TYPICAL DURATION:
10 seconds
DASH LAMPS:
MIL
VERIFICATION:
1. Rpm greater than 1500.
2. Torque demand on.
NOTE: If codes for other modules are present, fix those first.
PROBABLE CAUSES:
1. Improper programming of the CPC (Common Powertrain Controller).
2. Other failed modules on the truck (Transmission, ABS, Cab controller, etc…).
3. Battery/battery cable issues, or electrical issue on truck.
![download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software](https://www.ecuforcetruck.com/wp-content/uploads/2023/05/MPDR-3.7.00-300x300.png)
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
