Allison WTEC II Fault Code : 21 PID: SPN: 12 FMI: Throttle position sensor, failed low
Main code 21 indicates the throttle position sensor has been retracted or extended by its linkage into an error zone. Code 21 12 is set when the ECU receives TPS counts of 14 or less. Whenever a Code 21 XX condition is detected, the system
defaults to 100 percent throttle and part throttle shifts will be abrupt.
Possible causes:
Sensor
Wiring to the sensor or the ECM
PWM signal problem
Main code 21 indicates the throttle position sensor has been retracted or extended by its linkage into an error zone.
This may be due to a fault with the sensor, or a fault in the wiring to the sensor or to the ECU. This code may also
indicate a PWM signal problem. Code 21 12 is set when the ECU receives TPS counts of 14 or less. Code 21 23 is
set when the ECU senses TPS counts of 233?255. Whenever a Code 21 XX condition is detected, the system
defaults to 100 percent throttle and part throttle shifts will be abrupt.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
-
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS
