Cummins X15 CM2350 X116B Performance Series (2018 & Newer) Fault Code: 2738 PID: SID 237 SPN: 626 FMI: 3 Start Enable Device 1 Circuit (Ether Injection)- Voltage Above Normal or Shorted to High Source

Circuit Description
The ether injection circuit is a device used by the engine to control the ether injection operation. The ether injection circuit utilizes a Pulse Width Modulated (PWM) signal. A PWM signal is pulsed voltage signal between 0-VDC and system voltage. The frequency of the pulsed voltage signal is dependent on the application requirement.

Component Location
The control solenoid location varies by OEM. Refer to the appropriate OEM service manual to determine the location.

Conditions for Running the Diagnostics
This diagnostic runs when the keyswitch is in the ON position and when the pulse width modulated (PWM) device is getting energized or de-energized. In some cases, the diagnostics can also run at some fixed intervals.

Conditions for Setting the Fault Codes
The ether injection circuit pulse width modulated (PWM) signal detected a voltage greater than 0-VDC when the PWM signal was turned off by the ECM.

Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp immediately when the diagnostic runs and fails.
The ether injection operation will be disabled.
Conditions for Clearing the Fault Code
To validate the repair, perform a key cycle, and leave the key in the ON position for 1 minute.
The fault code status displayed by INSITE™ electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
The Reset All Faults command in INSITE™ electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Shop Talk
Possible causes of this fault include:

An open circuit in the engine harness or ether injection solenoid
A short circuit to voltage source in the OEM harness
A malfunctioning ECM.

Possible Cause:
1) Ether injection solenoid failure
2) OEM harness
3) ECM failure